REW Beta Release REW API beta releases

[John Mulcahy]

John, after the second impedance calibration step, the level value becomes -3.01 dB. Although before that I set -9.7 dB in the measurement window, and took the first calibration step.

I guess the level was -3 before you changed it to -9.7? I have fixed it for the next build.

 

[sm52]

I guess the level was -3 before you changed it to -9.7?

The level in the Measure window and in the Preferences window was -9.7. I installed them before calibration. Just in case, there is a video.

 

[John Mulcahy]

No need for a video, problem has already been fixed.

 

[sm52]

There was once an issue that the measurement window took a long time to load due to the FSAF setting, even if the FSAF tab was not used. In the latest versions, the measurement window does not allow me to do anything for 10 seconds after opening. Similar to what it was before.

 

[John Mulcahy]

Doesn't give me much to work with. Every time you open the Measure dialog or only the first time? What are your Measure dialog settings for SPL, FSAF and Impedance? Anything else you can say about when this happens?

 

[sm52]

This only happens the first time after running REW. All subsequent openings of the slowdown window are not present. Should I take screenshots of the settings of the three tabs?

 

[John Mulcahy]

Yes, please.

 

[sm52]

Settings for three tabs.

 

[John Mulcahy]

How long is the FSAF file? Does the Measure dialog open in FSAF mode when you get the delay or is it in SPL mode? Is there a Busy indicator shown during the delay?

 

[sm52]

FSAF file length is 35 MB. The delay appears with all three tabs with which REW was closed. But on the SPL and Impedance tab there is no delay indicator; a small window appears and disappears very quickly, the text of which is not visible. There is a delay indicator on the FSAF tab; it starts to 'spin', freezes almost immediately, and remains like that until the end of the 'Measurement' tab freezing.