sm52

I always check all options by ear. If you hear an improvement, then you can use this option. I have a categorical view on the...

It's just worth checking all the options. You will hear what is best.

Too much filter slope can make a bad sound. It is better to solve all issues in a maximum of 2nd order. If there is no reason to...

Based on measurements 7,8,9 of the second file, I would make the delay for the tweeter 1.2 ms, for the woofer 0.14 ms. I would divide...

Save half of the measurements as a separate file. Then the second half as a separate file.

It is better to show measurements before correction. On the general measurement, the additional impulse is a separate tweeter. It should...

If the three impulses are correctly timed, there should be one impulse when working together. If there are measurements of the three...

If the Earthworks answered that their microphone does not need a calibration file, then that's good. So you have a good microphone. But...

did something work out for you?

Select the asio driver in preferences/soundcard, your output device, output and reference output should be different. If the driver is...

One measurement was made at 48k, the other at 96k. But this is not the main question. Your REW version is 5.20.13. The latest version of...

Make sure both have Excl selected in the Preferences tab.

Yes, the reference must be the same for all measurements in the session.

very low fundamental signal.

jcandy Hello. There is a question how to fix the driver during the measurement of parameters. The driver must be positioned vertically...