Gobo Panel as an Option for long Home Theater?

[Jefferad]

I've setup my home theater in one end of a very long and narrow rectangle space in my basement - for simplicity, think 12'x40' ish. I have a ton of panels in the space between my seats and the screen including walls and ceilings which was a HUGE improvement. But, hearing ambient noise from HVAC and sounds coming down the hall from upstairs drives me crazy. And, my wife would appreciate any decrease at all in sound making it's way upstairs. While a permanent wall would be the best solution, I'm not sure I want to make that leap as it blocks off the screen from the rest of the space which is often used for entertainment while watching the screen from a distance. But, I'd love to block as much sound as possible. Any thoughts on maybe building 3 movable bogo panels on wheels to help reduce sound bleeding from the space? And, since I'm trying to block as much sound as possible, my questions include:

• should I build with a thin solid plywood backing or center (or even a pegboard with little holes) vs just cloth over Rockwool which I did for the panels on the walls and ceiling?
• If I do use a solid backing / center, is there any benefit to leaving an air gap between the solid panel and the insulation (similar to the gap I put when mounting other panels)?

Googling and searching YouTube shows many different approaches that seem often to be contradictory, so input is appreciated.

 

[ddude003]

Since you are trying to "block as much sound as possible"... I assume wide band... I would go with a solid backing maybe up to half inch, if you go thick, an air gap as much as you can do given your limits... Use MLV at the back... Pegboard for a center, with rock wool or the pink stuff at the front... And if your looking to keep some high frequencies in the room try some butcher paper on the front... Wrap the thing with your favorite acoustic cloth and your golden...

You might search the internet for a copy of Master Handbook of Acoustics by F. Alton Everest & Ken C. Pohlmann... There are several types and methods of acoustic absorbers described in this book... What I describe above is a hybrid of a few different systems...

 

[Todd Anderson]

Is this what you are talking about Jeff?

 

[Jefferad]

@Todd Anderson , yup. Do you think that could be a good solution?

 

[ddude003]

Those look nice @Todd Anderson and @Jefferad will need something much thicker for his application... I would suggest 12 inches thick at a minimum...

 

[Todd Anderson]

Maybe… I guess my concern is that you’re going to have a few issues.

One, every time you position them, they’re going to be different. How will that impact your Dirac room correction? You’re essentially changing your room every time they’re moved.

Two: leakage. You’re going to have sound finding its way around all of the openings on the top, bottom, and sides.

Something about this solution doesn’t feel right to me.

Have you thought about building a folding wall?

 

[Jefferad]

Thanks @ddude003 . I was thinking 8, but good to know that I should go even thicker. @Todd Anderson Yes I was thinking about the impact to room correction. Maybe I need to research if I can actually make a folding wall that applies a lot of the same concepts. Assume a lot of the same principles of design would be applicable. And yes, I know that a solid wall would be best.

 

[Todd Anderson]

I bet Scott would have some ideas on how to build a folding wall. Might make for a very viable option.

I guess you could always look to seal your entire long room with a door at the side. Have you looked into that?

 

[Jefferad]

Yeah, will look into the folding options as I can see that that would give the most predictable and stable room correction. You had previously suggested a permanent wall w/ a door, but again, when I have people over, they often sit at the bar or play pinball and still want to be able to watch the football game. So, I'd love to have an option to clear the line of site but put it back up for those times when it's just me watching a movie in the theater portion (most of the time!).

 

[Bob Rapoport]

Low bass travels through normal walls, you would need concrete barriers surrounding your basement to seal if off from being heard above. One less expensive solution to keep the wife happy is to listen with headphones, its immersive and brings the dialog right into your ears with no room interference. With today's wide dynamic range, the soft sounds are softer and the loud sounds are louder than ever before. If you adjust the volume for dialog clarity, you get blasted by the special effects, making it hard to get both just right all the time. Sennheiser offers the best solution, with adjustable volume control for each listener. https://us.sennheiser-hearing.com/collections/hearing/products/rs-5200 These make my wife the happiest and as we know, happy wife = happy life.

 

[DonH57]

A diagram would really help, showing stairs, doors, and other features including location of your mechanical room.

Isolation is a different (and usually much bigger) problem than controlling reflections using acoustic panels. The panels can help with higher-frequency sounds, but even then as mentioned above sound can easily sneak around the panels, and low bass travels through walls and ceilings despite the panels (which help somewhat but not so much for low bass). There is also transmission through HVAC ducts. Isolation usually requires heavy hanging walls and ceiling (plus floor if not at ground level) and duct mitigation (either baffle or remove and use an independent air system -- I used a minisplit for the media room so no ducts to the rest of the house). I attached a file showing what I did when they built our media room; not sure what or how much you want to do now. If you could wall off the area, or at least install a heavy (exterior with weather seals) door to the upstairs, that might help.

 

[ddude003]

You would place the gobo absorbers where you want them and then do the room correction... Place tape or sticky dots or magic marker where the footers for the gobos are... Move the gobos aside for what ever other purpose you want to open the room for... When done, place the gobos back to where the markers are... Hey, its a domestic room not a professional studio...