I'm trying to understand how to setup the Loopback connection in REW, so i can take measurements with an accurate timing reference.
I have the following gear:
Is the above Ok? Am i'm missing anything, or is anything incorrect?
Thank you in advance!
I have the following gear:
- Behringer UMC404HD
- Behringer ECM8000
- Topping PA5
- Laptop
- Connect Mic to UMC404HD (XLR to XLR)
- Connect Laptop to UMC404HD by USB
- Connect the Loopback connection on UMC404HD => Line input to Line Output => 6.35mm jack to splitter 2 x 6.35mm cable
- Connect L/R outputs on UMC404HD to Amplifier 6.35m inputs => 2 XLR to 6.35mm cables
- Connect Amplifier speaker outputs to speaker
Is the above Ok? Am i'm missing anything, or is anything incorrect?
Thank you in advance!