STI "Measurement bandwidth too narrow" error

[branv]

@John Mulcahy Hello, I ran into this error when trying to calculate STI with an imported impulse response. It is saying that my impulse response is not in range, but actually reads that it spans 0Hz to 16kHz. Attached is a screenshot of the verror. Do you know of a way around this?

 

[John Mulcahy]

Can you attach the impulse response or the mdat?

 

[branv]

Can you attach the impulse response or the mdat?

Here is the impulse response. these are exported from Treble, I am testing to see how well this works with simulated IRs

 

[John Mulcahy]

It runs normally for me. Which 5.40 build are you running? The latest is beta 96.

 

[branv]

I am on the latest version as well. Here is my mdat if you want to take a look

 

[John Mulcahy]

Thanks, I understand the issue. I'll fix it in the next build, but in the meantime it will calculate correctly if you apply smoothing (any smoothing) to the measurement. If you set the Analysis preference to Allow 96 PPO log spacing it should also work for any further imports.

 

[branv]

Amazing, thank you so much!