leedesert
Registered
Thread Starter
- Joined
- Jan 5, 2021
- Posts
- 1
More
- Preamp, Processor or Receiver
- Onkyo TX-NR747
- Universal / Blu-ray / CD Player
- Panasonic UBD-K8500, Xbox One X
- Front Speakers
- Klipsch R26FA
- Center Channel Speaker
- Klipsch RP-250C
- Surround Speakers
- Klipsch RP140D
- Front Height Speakers
- Klipsch R26FA
- Subwoofers
- SVS PB-2000 Pro
- Video Display Device
- Samsung 65"
- Remote Control
- Harmony Ultimate
Hello everyone, I'm new to the Forum and have not even had a chance to do test measurements or set up with REW yet. I traded my old pb-2000 in for the new pb-2000 Pro. SVS gave me a little over $500 for the trade-in.
I've been watching a lot of YouTube videos on how to set up the REW and also purchased the recommended microphone from Amazon.
My speaker setup is listed in my profile. I'm going to give it a shot and see how I do this weekend. Are there any recommendations for that particular subwoofer on initial setup? Should I leave everything on the subwoofer set at the factory default? On my Onkyo receiver what settings should I leave on, turn off, or reset before attempting the alignment? From everything I've seen it's suggested to run the receivers Auto Alignment first and then use our REW.
I appreciate any advice you can offer.
I've been watching a lot of YouTube videos on how to set up the REW and also purchased the recommended microphone from Amazon.
My speaker setup is listed in my profile. I'm going to give it a shot and see how I do this weekend. Are there any recommendations for that particular subwoofer on initial setup? Should I leave everything on the subwoofer set at the factory default? On my Onkyo receiver what settings should I leave on, turn off, or reset before attempting the alignment? From everything I've seen it's suggested to run the receivers Auto Alignment first and then use our REW.
I appreciate any advice you can offer.
