New to REW, upgraded to PB-2000 pro

leedesert

Registered
Thread Starter
Joined
Jan 5, 2021
Messages
1
More  
Preamp, Processor or Receiver
Onkyo TX-NR747
Universal / Blu-ray / CD Player
Panasonic UBD-K8500, Xbox One X
Front Speakers
Klipsch R26FA
Center Channel Speaker
Klipsch RP-250C
Surround Speakers
Klipsch RP140D
Front Height Speakers
Klipsch R26FA
Subwoofers
SVS PB-2000 Pro
Video Display Device
Samsung 65"
Remote Control
Harmony Ultimate
Hello everyone, I'm new to the Forum and have not even had a chance to do test measurements or set up with REW yet. I traded my old pb-2000 in for the new pb-2000 Pro. SVS gave me a little over $500 for the trade-in.
I've been watching a lot of YouTube videos on how to set up the REW and also purchased the recommended microphone from Amazon.
My speaker setup is listed in my profile. I'm going to give it a shot and see how I do this weekend. Are there any recommendations for that particular subwoofer on initial setup? Should I leave everything on the subwoofer set at the factory default? On my Onkyo receiver what settings should I leave on, turn off, or reset before attempting the alignment? From everything I've seen it's suggested to run the receivers Auto Alignment first and then use our REW.

I appreciate any advice you can offer.
 
Top Bottom