I am sure this is going to be a difficult one but I am hoping few of the experienced guys can chip in with there knowledge as this doesn't pertain only to REW. I am sure this has be done before to some extent...
I want to measure my system with my convolver on. The convolver usually loopsback with Cable Input(VB Audio Virtual Cable) with the correct settings in Hangloose.
I am using a Scarlett 6i6 and If my supposition is correct I use the SPIF output and connect it to one of the digital inputs on the Marantz AV7005.
In REW do I use ASIO? And if so then below is a picture of the settings in the Scarlett mix controller, does this look right?
I want to measure my system with my convolver on. The convolver usually loopsback with Cable Input(VB Audio Virtual Cable) with the correct settings in Hangloose.
I am using a Scarlett 6i6 and If my supposition is correct I use the SPIF output and connect it to one of the digital inputs on the Marantz AV7005.
In REW do I use ASIO? And if so then below is a picture of the settings in the Scarlett mix controller, does this look right?