Hi,
I have purchased a Umik-2. I also own a Umik-1 (which is defect), and made 100's, if not 1000's of measurements on the speakers I am developing with the Umik-1.
With the Umik-2, I have not been able to produce a consistent and correct measurement. I run on a Mac (REW V5.20.3 - JRE 1.8.0_302 64-bit on OS X 10.12.6). When selecting 48khz or 96khz, each measurement looks different (as in all over the place), the impulse reponse is a mess and my measurement (on the same, unchanged speaker) is different every time, even if I don't change any settings.
I have replaced pretty much everything in my setup to exclude any possible causes, new cables, other laptop etc etc. I cannot create a single consistent measurement.
Are there known issues with the UMIK-2? Can anyone provide any help or insight? I am pretty stuck at the moment, not being able to use my favorite measurement tool.
Any pointers or help to troubleshoot this is appreciated.
Stefan
I have purchased a Umik-2. I also own a Umik-1 (which is defect), and made 100's, if not 1000's of measurements on the speakers I am developing with the Umik-1.
With the Umik-2, I have not been able to produce a consistent and correct measurement. I run on a Mac (REW V5.20.3 - JRE 1.8.0_302 64-bit on OS X 10.12.6). When selecting 48khz or 96khz, each measurement looks different (as in all over the place), the impulse reponse is a mess and my measurement (on the same, unchanged speaker) is different every time, even if I don't change any settings.
I have replaced pretty much everything in my setup to exclude any possible causes, new cables, other laptop etc etc. I cannot create a single consistent measurement.
Are there known issues with the UMIK-2? Can anyone provide any help or insight? I am pretty stuck at the moment, not being able to use my favorite measurement tool.
Any pointers or help to troubleshoot this is appreciated.
Stefan