Hey,
I'm using Focusrite Saffire 24 DSP Pro.
I was trying to calibrate the EQ Romm Wizard, but when I follow the instruction, the software doesn't see any input (screenshot below).
Normally when I play using the same inputs, they work as they should inside my DAW, but the EQ Room Wizard somehow doesn't see it.
I contacted Focusrite asking about any specific card settings and they wrote "There shouldn't be any specific settings you need to apply in Mix Control. Mix Control will only deal with output routing, a signal sent into analogue input one will always appear on this input. "
Any advice? I would love to calibrate everything to correct the sound treatment of my room.
I'm looking forward to hearing from you,
Cheers
I'm using Focusrite Saffire 24 DSP Pro.
I was trying to calibrate the EQ Romm Wizard, but when I follow the instruction, the software doesn't see any input (screenshot below).
Normally when I play using the same inputs, they work as they should inside my DAW, but the EQ Room Wizard somehow doesn't see it.
I contacted Focusrite asking about any specific card settings and they wrote "There shouldn't be any specific settings you need to apply in Mix Control. Mix Control will only deal with output routing, a signal sent into analogue input one will always appear on this input. "
Any advice? I would love to calibrate everything to correct the sound treatment of my room.
I'm looking forward to hearing from you,
Cheers