Rather than starting another post, I have a similar question. I am using an alpine pxa-h800 in an automobile. Trying to get rew setup and optimized for my system. I see it has an option for the fosgate 360.2 and some other mobile dsp's. What would be a close match to my dsp. Or the correct way to configure rew so it is the same for eq. Also I am utterly clueless about rew and am setting up a very complex 3 way front stage with subs in stereo ( I know I know, but what in the world lol(. 8 channels for now, but ultimately I will be using 10 channels, with rear fill in the rear doors.
So is there some sort of step by step blow by blow writeup for optimizing rew to your system's specs? This is all brand new to me, and I am probably over my head but I have bkught good equipment and the installation is solidly planned and executed... now comes the tuning, thus far all I have done is set crossover points to where I have no risk of damaging drivers, and set amp gains with an ohm meter to rated output, given they are high quality pieces there is no clipping, but far from optimized or level matched... a guide that will spoon feed me the info at a digestible pace that is not overloaded with technical lingo? Does it exist?