Delays and Simulation

[Trdat]

I know delays have to be within a ms of each other, however that is from left to right. What would be an acceptable delay on the measurements between tweeter and bass? Are these delays acceptable?

And does going into analysis measurement- step response measurement bring up the initial measurement to analyze the generated correction filter? How do I check my step response on the simulated measurement?

 

[juicehifi]

I only look at the tweeter delays. They are spot on here, so worries.

Low frequency drivers’ peak can vary due to high and sometimes variable rise time.

 

[Trdat]

I only look at the tweeter delays. They are spot on here, so worries.

Low frequency drivers’ peak can vary due to high and sometimes variable rise time.

Great, so only tweeter left and right.

And can you remind me how I check my step response and pre-ringing after generating a filter. Can't remember if I go into analysis measurement or analysis simulation?