-
-
-
juicehifi replied to the thread low volume on sweeps.What do the measured impulse responses look like? Can you pust a zoomed image of the two?
-
juicehifi replied to the thread low volume on sweeps.Hi Climbclimb, The default in the measuremen module is minus 20 dB. It is set low to protect rigs with very high sensitivity. Perhaps...
-
juicehifi replied to the thread W11 stability.I'd say yes for Audiolense. There may be slightly more people who experiences measurement problems now than a couple of years back, but...
-
juicehifi replied to the thread Beginner trying to figure stuff out..Yes.
-
juicehifi replied to the thread Beginner trying to figure stuff out..The measurement looks fine from here. I recommend that you experiment with different target shapes in the bottom. What you have here...
-
juicehifi replied to the thread Measurement Sweep File - Pops, Clicks.This report hasn’t detected any problems. The images at the bottom at templates that you should use to examine the sweep if you are...
-
juicehifi replied to the thread Soundstage issues.I hope you did a new measurement as well. The correction is very sensitive to speaker placement.
-
juicehifi replied to the thread New Audiolense releases.If I allowed for 400 kHz measurements it would lead to a filter generation of lesser quality. 88.2 and 96 kHz is imo the sweet spot...
-
juicehifi replied to the thread Audiolense for Car Audio.:T
-
juicehifi replied to the thread Audiolense for Car Audio.The trial version allows for correcting 90 seconds of wave filed music, but only for regular stereo. In addition, you can save dummy...
-
juicehifi replied to the thread Audiolense for Car Audio.Hi there, You need Audiolense xo for this task. Audiolense does multichannel measurement, so all timing differences between drivers...
-
juicehifi replied to the thread Level of low shelf on targets, is very low bad?.I believe it should be OK as long as it is levelled out close to 0 Hz and close to FS/2. A steep drop at the extremes creates some...
-
juicehifi replied to the thread How can I get Audiolense to import .mdat files?.Glad to hear that, Joel. The logic is simply that I need to be able to verify the measurement behind a correction that is perceived as...
-
juicehifi reacted to joelha's post in the thread How can I get Audiolense to import .mdat files? with
Like.
Thanks very much for your reply, Bernt. In fact, only today, I started taking measurements using your software. I can not only see the...
-
-
Loading…
-
Loading…
