I am trying to measure the output of my subwoofer to the CEA-2010 or CTA-2043 limits but the limits do not appear. I searched the forum and help but I cannot find any reference to how I should see the limits in the RTA window.
At some point I did see the limit curve flash on the screen while adjusting setup parameters but I have not been able to reproduce this. The signal displayed on the screen is definitely above CEA2010 THD+N limits but there's no indicator telling me it is?!
The same result was found with V20 beta 6 and V20 beta 29. I am using windows 10 with the 32 bit version of REW.
The attached screen cap is a highly distorted 10Hz burst.
At some point I did see the limit curve flash on the screen while adjusting setup parameters but I have not been able to reproduce this. The signal displayed on the screen is definitely above CEA2010 THD+N limits but there's no indicator telling me it is?!
The same result was found with V20 beta 6 and V20 beta 29. I am using windows 10 with the 32 bit version of REW.
The attached screen cap is a highly distorted 10Hz burst.