STI "Measurement bandwidth too narrow" error

branv

Registered
Thread Starter
Joined
Jul 23, 2025
Posts
4
@John Mulcahy Hello, I ran into this error when trying to calculate STI with an imported impulse response. It is saying that my impulse response is not in range, but actually reads that it spans 0Hz to 16kHz. Attached is a screenshot of the verror. Do you know of a way around this?

1753301033517.png
 
Thanks, I understand the issue. I'll fix it in the next build, but in the meantime it will calculate correctly if you apply smoothing (any smoothing) to the measurement. If you set the Analysis preference to Allow 96 PPO log spacing it should also work for any further imports.
 
Back
Top