4Bettersonar
Registered
Thread Starter
- Joined
- May 21, 2022
- Messages
- 4
More
- Preamp, Processor or Receiver
- Denon AVR X1400H
- Main Amp
- Mcintosh MA 8950
- Universal / Blu-ray / CD Player
- LG Blue-Ray
- Front Speakers
- Dynaudio Evoke 50, Focal Kanta 2
- Subwoofers
- SVS SB2000
Hello,
I am a beginner in this area for measuring my room acoustics for speakers. I purchased Emm6 mic. As a voltage source for the mic I wan to use Behringer mixer (Xenics Q802 USB) which I already owned for Zoom recording with laptop.
1.Is it right that I use Behringer mixer (Q802 USB) as a phantom voltage source for the mic for REW measurement? Because
2. In the detected input device on REW, I do not see emm6 as identified device. Instead, I see USB Codex which is the Behringer mixer's name.
Should I see the EMM 6 instead to use this mic in the input device window? If not, would a Focusrite Solo( that REW recommended on the first page) works better than Behringer mixer? I though any voltage source would do, but I am not sure for the reason I mentioned above.
Thanks,
Don
I am a beginner in this area for measuring my room acoustics for speakers. I purchased Emm6 mic. As a voltage source for the mic I wan to use Behringer mixer (Xenics Q802 USB) which I already owned for Zoom recording with laptop.
1.Is it right that I use Behringer mixer (Q802 USB) as a phantom voltage source for the mic for REW measurement? Because
2. In the detected input device on REW, I do not see emm6 as identified device. Instead, I see USB Codex which is the Behringer mixer's name.
Should I see the EMM 6 instead to use this mic in the input device window? If not, would a Focusrite Solo( that REW recommended on the first page) works better than Behringer mixer? I though any voltage source would do, but I am not sure for the reason I mentioned above.
Thanks,
Don