Hi,
REW allows you to enter a target curve and will provide PEQ parameters to correct a measured signal to match the target. I'd like to use that capability generate PEQ parameters to correct a target curve to be 'flat'. I probably could figure a way to 'record' a flat curve, but it would be nice if I could just ask REW to generate the parameters for a flat measurement.
What I'm trying to do:
I have some headphones (HD600 In this case). I'd like to EQ the low end response to extend the bass beyond what the drive does naturally. So I want to enter the HP's frequency response curve as my 'target curve' and have REW generate the PEQ parameters that would convert a flat curve to this response. I can then take the REW filter paramaters and invert the gain coefficients so that it would 'correct'' the target curve (which is my FR) back to a flat curve which is what I want.
Is there way to do that now? Is this a function that could be added? If it would be added as a feature, it might be a bit better if could enter two curves - the starting curve and the target curve and then do what you would normally do with REW (i.e. correct a measurement to match a target with PEQs). This amounts to giving me a way to enter a curve for what the 'measurement' is. For HPs, there is no way for me to measure what the head phone frequency response is at my eardrum (without buying a very expensive apparatus that emulates a head and ear).
REW allows you to enter a target curve and will provide PEQ parameters to correct a measured signal to match the target. I'd like to use that capability generate PEQ parameters to correct a target curve to be 'flat'. I probably could figure a way to 'record' a flat curve, but it would be nice if I could just ask REW to generate the parameters for a flat measurement.
What I'm trying to do:
I have some headphones (HD600 In this case). I'd like to EQ the low end response to extend the bass beyond what the drive does naturally. So I want to enter the HP's frequency response curve as my 'target curve' and have REW generate the PEQ parameters that would convert a flat curve to this response. I can then take the REW filter paramaters and invert the gain coefficients so that it would 'correct'' the target curve (which is my FR) back to a flat curve which is what I want.
Is there way to do that now? Is this a function that could be added? If it would be added as a feature, it might be a bit better if could enter two curves - the starting curve and the target curve and then do what you would normally do with REW (i.e. correct a measurement to match a target with PEQs). This amounts to giving me a way to enter a curve for what the 'measurement' is. For HPs, there is no way for me to measure what the head phone frequency response is at my eardrum (without buying a very expensive apparatus that emulates a head and ear).
Last edited: