REW spl

mfinzi

Registered
Thread Starter
Joined
May 27, 2019
Messages
10
Greetings, l need clarification, most frequency response measurements are set at db/2.83v/ m. Assuming l have gone through all REW SETUP PRELIMINARIES and my measurement mic and speaker are 1m apart, would l be correct to state that my response would be at 2.83v/m regardless of the power of the output amp. Regards
 

John Mulcahy

REW Author
Joined
Apr 3, 2017
Messages
7,212
You would need to adjust the signal level and output path volume controls to achieve 2.83V measured at your speaker terminals. The amp's power doesn't particularly matter, but its gain does.
 

mfinzi

Registered
Thread Starter
Joined
May 27, 2019
Messages
10
You would need to adjust the signal level and output path volume controls to achieve 2.83V measured at your speaker terminals. The amp's power doesn't particularly matter, but its gain does.
Thanks, great regards
 
Top Bottom