Hi, I use rew 5.2 with HDMI and umik and has been working well until I recently installed the software for a minidsp ddrc-24.
I installed the minidsp software and ran dirac through the same laptop and then went to take some rew measurements but they were all over the place.
I have since removed everything from the chain so back to laptop umik av receiver rca to subwoofer but all my subwoofer measurement stop due to clipping at very low levels.
I now notice that under asio devices I have asio4all v2 (which is selected) but in the drop down there is now an option for minidsp asio driver which was not there before so must be part of the Minidsp ddrc install.
I have tried a fresh install of rew and still the same.
I could try installing all the minidsp software but I want to make sure I am not missing something easier first.
Has anyone come across this before?
I installed the minidsp software and ran dirac through the same laptop and then went to take some rew measurements but they were all over the place.
I have since removed everything from the chain so back to laptop umik av receiver rca to subwoofer but all my subwoofer measurement stop due to clipping at very low levels.
I now notice that under asio devices I have asio4all v2 (which is selected) but in the drop down there is now an option for minidsp asio driver which was not there before so must be part of the Minidsp ddrc install.
I have tried a fresh install of rew and still the same.
I could try installing all the minidsp software but I want to make sure I am not missing something easier first.
Has anyone come across this before?