Question about the rew alignment tool!!

Lba

Registered
Thread Starter
Joined
Jan 15, 2024
Posts
26
Hello how are you?

Actually, more than one question, it's two, or perhaps an entire concept.

I'm taking measurements on an Ambisonics system (8 channels up to now). So far, I've taken some measurements and noticed they're pretty aligned once I use the EQ tool. Does this tool also phase-align the measured channels?

And then, regarding the other question about the alignment tool, once I've aligned the two signals, is there a way to apply them to the channel that needs a corresponding delay?

Greetings!
 
EQ only addresses magnitude. REW can only calculate delays, it has no means of applying them to the system that was measured For your measurements to be meaningful they must be made with a timing reference.
 
Back
Top