Good day all,
I'm running some auto calibration test to better integrate my system, (7.4.4). Before time aligning(phase aligning) the subs to the mains, I'm seeing that the calibration results when zoomed in, show a slight difference in Impulse response timing. these are all in very small range all less than a MS of difference, but I'm wondering if I should still tweak them to get them to overlap at zero (0)? I make small distance changes in my AVR settings to correct this, and the move on to using the TIME ALIGNMENT tool in REW to then phase align the SUB(s) with the MAINS at the crossover point.
I'v
e included a pic for reference.
I'm running some auto calibration test to better integrate my system, (7.4.4). Before time aligning(phase aligning) the subs to the mains, I'm seeing that the calibration results when zoomed in, show a slight difference in Impulse response timing. these are all in very small range all less than a MS of difference, but I'm wondering if I should still tweak them to get them to overlap at zero (0)? I make small distance changes in my AVR settings to correct this, and the move on to using the TIME ALIGNMENT tool in REW to then phase align the SUB(s) with the MAINS at the crossover point.
I'v