Display Target House Curve in EQ or RTA Window?

BartStephens

Registered
Thread Starter
Joined
Jun 22, 2020
Messages
2
Location
Birmingham, AL
My AV System  
Preamp, Processor or Receiver
Parasound JC 2 BP+
Main Amp
Parasound JC5
DAC
dCS Bartok
Front Speakers
Wilson Yvette
Streaming Equipment
Roon Nucleus +
Streaming Subscriptions
Qobuz
Other Equipment
Car Audio: Kenwood Exceleon > AudioControl DSP Amps > Morel 3way component speaker w/ active crossover; JL Audio sub
Hello,
I am trying to tune a system (6 drivers with active crossovers and 30-band EQ) to match a house curve.

It would seem that the easiest way to do this would be to display the Target Curve in the RTA window so I can see how actual Pink Noise compares to the the target curve, but I cannot figure out how to do this within REW. I have loaded my curve (Preferances>House Curve) and I can see the curve in the EQ window, but I really need to see it for comparison with "live" sound in the RTA window. Possible? Is my approach flawed?

Bonus:
I am also a little confused by the myriad options and graph controls in RTA. I assume I want to use straight SPL (vs. dBc)? I wish there was a way to display RTA graph with 30 bands that matched the system EQ I am using.

Thanks,
Bart
 

BartStephens

Registered
Thread Starter
Joined
Jun 22, 2020
Messages
2
Location
Birmingham, AL
My AV System  
Preamp, Processor or Receiver
Parasound JC 2 BP+
Main Amp
Parasound JC5
DAC
dCS Bartok
Front Speakers
Wilson Yvette
Streaming Equipment
Roon Nucleus +
Streaming Subscriptions
Qobuz
Other Equipment
Car Audio: Kenwood Exceleon > AudioControl DSP Amps > Morel 3way component speaker w/ active crossover; JL Audio sub
Thank you for quick reply, John. Very helpful.
 
Top Bottom