DonMK
Registered
Thread Starter
- Joined
- Dec 11, 2025
- Posts
- 1
More
- Preamp, Processor or Receiver
- UNIVERSAL AUDIO UAD APOLLO X8 AND QUAD
- Computer Audio
- MAC STUDIO MAX M1 32GB UNIVERSAL AUDIO LUNA PRO
- Front Speakers
- FOCAL TRIO 6 ST, GENELEC 8030C, AVANTONE MIXCUBES, MACKIE HR824 MK2
- Subwoofers
- XTZ 12.17 EDGE X2
- Other Speakers
- QSC K10.2 PA
- Screen
- Samsung q90r
- Remote Control
- GOT SOME
- Cables
- LOADS
- Satellite System
- HUMAX FREESAT
- Headphones/IEMs
- NAUMAN NDH30, SHURE SE535
- Headphone DAC/Amp
- UNIVERSAL AUDIO UAD APOLLO X8, AUDIENT NERO
Hi all , having dabbled with REW and minidsp/dirac in an AV setup previously I thought Id come along and seek help to use REW to properly setup my home studio , My set up is slightly complex at the moment and having wasted a lot of time and money on the wrong software solution I remembered that REW could do a far better job so basics of the system = Mac tahoe 26.1 , audio interface = UA Apollo x8 & 8Quad currently run in a 2.1 config , I connect stereo balanced trs analogue out connects to Audient NERO main in monitor controller , I also take a mirrored digital spdif coaxial into a coaxial-Toslink convertor and connect digitally to minidsp 2x4HD which then sends an unbalanced RCA connection to Audient as aux in full range and two RCA outs to my XTZ 12.17 subs x2 after xover and peq the Audient then feeds out balanced connections to 3 pairs of monitors Focal trio 6 st , Genelec 8030c and a pair of Avantone mixcubes, Scratching my head to think what is the best way to get this system set up with properly aligned subs which at present are independent and fed by the 2x4hd of the full range signal so any help on this front will be greatly appreciated , thanks again for the add .Don
