Hi,
I did my first sound card calibration for the UR22C audio interface using a dual-channel setup with the output looped back from the amp to the input.
My settings are..
Sample rate: 96K
Buffer : 128K (in preferences)
Sweep Length : 512K (in measurement window)
1. Are those wiggles ok? The REW documentation says to expect "variations much less than 1dB". Each time I run this I get slightly different results. The worst I got was +1.8dB -1.9dB.
2. Are the settings fine? Should I try different settings?
3. Is it ok to have the timing reference plugged in while doing this or should that be disconnected?
Thanks.
I did my first sound card calibration for the UR22C audio interface using a dual-channel setup with the output looped back from the amp to the input.
My settings are..
Sample rate: 96K
Buffer : 128K (in preferences)
Sweep Length : 512K (in measurement window)
1. Are those wiggles ok? The REW documentation says to expect "variations much less than 1dB". Each time I run this I get slightly different results. The worst I got was +1.8dB -1.9dB.
2. Are the settings fine? Should I try different settings?
3. Is it ok to have the timing reference plugged in while doing this or should that be disconnected?
Thanks.