Select frequency range

[janbth]

Is there a way to select a freqency range from a measurement for further analysis? I know that an interval can be chosen *before* doing a measurement, but what about *after* a full measurement has been made? I would like to do some experimentation with subwoofer integration.

 

[John Mulcahy]

Why would the range of the measurement make a difference?

 

[janbth]

I would like to compare the impulse response of my subs to the impulse response of the mains. The IR from the (FFT of the) full frequency range would not work, but restricting the range to an interval around the crossover might. In this interval the subs and mains overlap. The idea is to align the peaks in the «restricted IR». (I hope this makes sense...)

 

[John Mulcahy]

Use the Impulse alignment mode of the alignment tool in the 5.20.14 early access build, that will apply a bandpass filter to each impulse response and align those filtered responses.

 

[janbth]

Ok, that sounds like what I was looking for. I will check it out. Thanks!