I have a 3.1 setup and am using a MAC and REW 5.20.14 a couple issues I noticed:
1) When I do Check Levels - Sometimes the sound is deafening loud sometimes it is quiet, even if I don't adjust any settings
2) When I do Check Levels and choose "R", the sound is coming from both "R" and "L" channels - is that expected?
3) Intermittent - When I run REW sweeps, the sound from the Right speaker is MUCH louder than the Left. However, when I do "test tones" in the receiver, they are matched. Any ideas?
4) When I run measurements of my towers in Full range, I am getting inconsistent results each time I run it in the < 50hz range. How do I get more consistency? Or do I just run 5-10 measurements and AVG them?
Thanks!
1) When I do Check Levels - Sometimes the sound is deafening loud sometimes it is quiet, even if I don't adjust any settings
2) When I do Check Levels and choose "R", the sound is coming from both "R" and "L" channels - is that expected?
3) Intermittent - When I run REW sweeps, the sound from the Right speaker is MUCH louder than the Left. However, when I do "test tones" in the receiver, they are matched. Any ideas?
4) When I run measurements of my towers in Full range, I am getting inconsistent results each time I run it in the < 50hz range. How do I get more consistency? Or do I just run 5-10 measurements and AVG them?
Thanks!