Andreas Stickel
Registered
Thread Starter
- Joined
- Nov 16, 2023
- Messages
- 1
Hello,
I have a question about a measurement mismatch in REW (see attached screenshot):
1. the red graph shows a measurement of a white noise file played back via VLC player, filtered by an audio processing software and captured directly in REW
2. the blue graph shows the same setup but the audio processing software output recorded in Reaper. The recorded file was exported and imported into REW.
So one was directly captued and the other one was imported.
Can anyone give any advice on this?
Thanks
I have a question about a measurement mismatch in REW (see attached screenshot):
1. the red graph shows a measurement of a white noise file played back via VLC player, filtered by an audio processing software and captured directly in REW
2. the blue graph shows the same setup but the audio processing software output recorded in Reaper. The recorded file was exported and imported into REW.
So one was directly captued and the other one was imported.
Can anyone give any advice on this?
Thanks
