Problem importing IR text files into Hypex HFD

Vorreux

Registered
Thread Starter
Joined
May 22, 2017
Messages
14
More  
Preamp, Processor or Receiver
Najda
Main Amp
ROTEL
Additional Amp
CROWN
Subwoofers
PHLAudio
Other Speakers or Equipment
TAD TD2001
Hello everyone,
I recently purchased two Hypex FA503 plate amplifiers, and I'm having problems using the HFD software.
This software allows you to import IRs in text format.
But when I look at the imported curve in the filter design, I see a curve identical to the one measured, but the horizontal scale is completely different.
Has anyone come across the same problem?
Are there any solutions?
REW.jpg

Réponse importée.jpg


Regards,

Pascal
 

Vorreux

Registered
Thread Starter
Joined
May 22, 2017
Messages
14
More  
Preamp, Processor or Receiver
Najda
Main Amp
ROTEL
Additional Amp
CROWN
Subwoofers
PHLAudio
Other Speakers or Equipment
TAD TD2001
Thank you John,
But is it possible to "recover" existing files?
Attached is the text file of the curve I posted.
Otherwise, for future measurements, are there particular settings to use in REW?

Regards,

Pascal
 

Attachments

  • Test file.txt
    452.6 KB · Views: 6

John Mulcahy

REW Author
Joined
Apr 3, 2017
Messages
7,403
From the sample interval value that data is at 11.025 kHz. If you drag that file onto the REW window it will import it, and show 11.025 kHz as the sample rate on the Info panel. You could then export the IR as WAV at 44.1 kHz and import that to REW, and finally export that IR file as text to get a 44.1 kHz file per the original measurement.
 

Vorreux

Registered
Thread Starter
Joined
May 22, 2017
Messages
14
More  
Preamp, Processor or Receiver
Najda
Main Amp
ROTEL
Additional Amp
CROWN
Subwoofers
PHLAudio
Other Speakers or Equipment
TAD TD2001
Hello John,

Thanks a lot, it works perfectly!
But I'll get there much quicker by using REW's EQ functions, which are really remarkable, and by transferring their parameters to the Hypex crossover settings...
Thanks again!

Pascal
 

Vorreux

Registered
Thread Starter
Joined
May 22, 2017
Messages
14
More  
Preamp, Processor or Receiver
Najda
Main Amp
ROTEL
Additional Amp
CROWN
Subwoofers
PHLAudio
Other Speakers or Equipment
TAD TD2001
Hi John,

Almost all the measurements I've made over the last 10 years have been at a sample rate of 48 kHz.
I searched and finally found a few made with a 44.1kHz sample rate, and these are imported into HFD without any problem!
Good to know...

Pascal
 
Top Bottom