TechEnthusiast
Registered
Thread Starter
- Joined
- Jan 3, 2024
- Posts
- 1
More
- Preamp, Processor or Receiver
- Yamaha RX-A3060
- Main Amp
- B&K AV5000 Series II
- Additional Amp
- AVR
- Other Amp
- Adcom GFA-535
- DAC
- RME ADI-2 DAC
- Streaming Equipment
- Sonus
- Front Speakers
- Sonus Faber GP Home
- Center Channel Speaker
- Sonus Faber GP Home swapped out for JBL Stage 125
- Surround Speakers
- Klipsch s-10
- Front Height Speakers
- Polks
- Rear Height Speakers
- Polks
- Subwoofers
- Dual SVS Pb2000 Pro's
- Video Display Device
- Sony 75"
I have watched videos and read the directions and even reached out to Ed at SVS. I cannot seem to get it to work. Perhaps it is my Lenovo Laptop (Yoga/Win10/64).
Getting an error that shows the S/N is low, 2db and suggests Increasing the sweep. I get other warnings and when I try to level match in the preferences In/Out it gets way too Loud!
Just as I am typing this another update came in hopefully that is the remedy.
Using both Dayton MM6 and Unik1 to see which is better.
I have been getting some results that look pretty good for my dual SVS PB2000 Pros, but unsure if they are accurate due to the sound card file issues.
Thanks
Getting an error that shows the S/N is low, 2db and suggests Increasing the sweep. I get other warnings and when I try to level match in the preferences In/Out it gets way too Loud!
Just as I am typing this another update came in hopefully that is the remedy.
Using both Dayton MM6 and Unik1 to see which is better.
I have been getting some results that look pretty good for my dual SVS PB2000 Pros, but unsure if they are accurate due to the sound card file issues.
Thanks
