How to apply a measured compensation EQ curve into a DAW that is using ASIO?

[Sacco_Belmonte]

I'm awaiting my UMIK-2 I recently ordered.

Now about REW and DAWs:

I know I can use EQ APO in a directsound device. That's out of the question. (will do to my system sound device)

But what about a DAW using ASIO? (ASIO bypasses directsound)

Should any decent convolution plugin do the trick? Do you have any recommendations?

System is:

5900X 64GB RAM muscle based workstation PC

TASCAM 16x08 interface

Presonus Monitor Station v2

Genelec 8040a

Thank in advance.

 

[Sacco_Belmonte]

Solved.

Any decent convolution plugin works just fine.

Although is better to EQ manually cause room correction, while good, it can make your room too flat.

So what I did was to measure my room (5 takes at slightly different positions) , take the average and make correction filters, apply to EQ APO and tweak it a bit (mostly the far ends not as flat).

Then replicate the EQ in APO in a EQ2 in FL Studio.

Seems like room correction is not an absolute thing (for non scientific tasks) and there is a bit of taste involved. At least for music composition/mixing.