lbstyling
New Member
Thread Starter
- Joined
- Mar 8, 2020
- Messages
- 7
More
- Preamp, Processor or Receiver
- PC
- Main Amp
- Hypex Ncore
- Front Speakers
- DIY
Hello,
This is a sweep of my JBl 2452H compression driver attached to a JMLC 350hz horn with a 3D printed throat connector to match the driver exit and horn entrance angle.
Measurement was done at 5cm from the mouth.
Questions:
1) I take it the phase moving all over the place is a result of the diaphragm breakup from 7khz upwards?
2) I wish to use RePhase. Any tips?
3) How do I take gated measurements?
4) As I am using IIR filters, am I correct in saying that the difference from FIR to IIR is that IIR is not linear phase?
Any comments or opinions welcome!
This is a sweep of my JBl 2452H compression driver attached to a JMLC 350hz horn with a 3D printed throat connector to match the driver exit and horn entrance angle.
Measurement was done at 5cm from the mouth.
Questions:
1) I take it the phase moving all over the place is a result of the diaphragm breakup from 7khz upwards?
2) I wish to use RePhase. Any tips?
3) How do I take gated measurements?
4) As I am using IIR filters, am I correct in saying that the difference from FIR to IIR is that IIR is not linear phase?
Any comments or opinions welcome!
Attachments
Last edited:
