Hi there.
I'd appreciate help on a long term problem with CEA-2010 tone burst measurements in REW: the limit curve just flashes for a very short period, then disappears. I've followed the help section on the signal generator, and have tried adjusting all other settings (especially the "Update" and "Peak hold" points) as well. Nothing helped. Here's a screen recording of a couple of tries:
Each times the curves appear and then disappear very quickly. This is of a loopback measurement on my PC, but the exact same happens when using a measurement mic to measure a loudspeaker on my laptop.
I'd appreciate help on a long term problem with CEA-2010 tone burst measurements in REW: the limit curve just flashes for a very short period, then disappears. I've followed the help section on the signal generator, and have tried adjusting all other settings (especially the "Update" and "Peak hold" points) as well. Nothing helped. Here's a screen recording of a couple of tries:
Each times the curves appear and then disappear very quickly. This is of a loopback measurement on my PC, but the exact same happens when using a measurement mic to measure a loudspeaker on my laptop.
