If I may ask for verification, tips, or suggestions etc...
I generated test tones starting at 10hz to 300hz for subs and 10hz to 20,000hz for mains. Then applied psychoacoustic smoothing for the graphs.
Here's both Tekton 4-10 subwoofers:
And here's the summation total of 2.2 channels after filters:
After only my first few hours ever working w/ REW I'm not sure if I'm doing this "optimally" but I measured each speaker [mains and subs] individually and applied created biquad filters to each channel's outputs on a Minidsp 2x4 HD. Then, I began measuring summed response and created a summed biquad filter and imported it into the 2x4 HD's inputs.
Could someone verify that the way I applied the summed filters to the inputs of the 2x4HD is okay? Also, I'm open to suggestions because I'm a beginner w/ REW not even a Novice as of yet!
Appreciate the dedication and work which went into REW!
I generated test tones starting at 10hz to 300hz for subs and 10hz to 20,000hz for mains. Then applied psychoacoustic smoothing for the graphs.
Here's both Tekton 4-10 subwoofers:
And here's the summation total of 2.2 channels after filters:
After only my first few hours ever working w/ REW I'm not sure if I'm doing this "optimally" but I measured each speaker [mains and subs] individually and applied created biquad filters to each channel's outputs on a Minidsp 2x4 HD. Then, I began measuring summed response and created a summed biquad filter and imported it into the 2x4 HD's inputs.
Could someone verify that the way I applied the summed filters to the inputs of the 2x4HD is okay? Also, I'm open to suggestions because I'm a beginner w/ REW not even a Novice as of yet!
Appreciate the dedication and work which went into REW!
Last edited:
