MichaelBreer
Registered
Thread Starter
- Joined
- Feb 7, 2026
- Posts
- 1
More
- Preamp, Processor or Receiver
- Intel Nuc, Roon
- Main Amp
- Hypex FA503
- Additional Amp
- None
- DAC
- Singxer SU-6 DDC
- Music Server
- Roon
- Streaming Equipment
- Roon
- Front Speakers
- DIY: SB Acoustics, Audiotechnology, Scanspeak
.
I just changed from Acourate into Audiolense and the user interface is quite a lot easier.
But, I ran into a kind of a strange behavior: massive difference between measured output Left/Right speaker channels.
This leads to a convolver file damping Right channel so it is barely audible.
I use Dayton XLR microphone via Focusrite 2i2 into Intel NUC.
Output from PC via Singxer SU-6.
I use Focusrite ASIO driver and the Singxer driver.
If I run a frequency sweep via REW, all is within 5dB….here we talk about +20 dB difference.
Any ideas?
Thanks i advance, Michael
I just changed from Acourate into Audiolense and the user interface is quite a lot easier.
But, I ran into a kind of a strange behavior: massive difference between measured output Left/Right speaker channels.
This leads to a convolver file damping Right channel so it is barely audible.
I use Dayton XLR microphone via Focusrite 2i2 into Intel NUC.
Output from PC via Singxer SU-6.
I use Focusrite ASIO driver and the Singxer driver.
If I run a frequency sweep via REW, all is within 5dB….here we talk about +20 dB difference.
Any ideas?
Thanks i advance, Michael
Last edited:
