sound card

Hello, I am trying to set up REW on my PC with a UMIK-1 and I am getting an error stating 'the soundcard did not provide any input data from microphone' when I try to use the SPL meter to calibrate the level according to the setup instructions on the mini dsp website. After a few seconds I get...

Hey, I am new to this community. I am planning to build in house 7.1.4 Dolby Atoms setup with active monitor. I am confused here there are two options to use one is the sound card and audio interface to connect these many outputs. The question is after I will do the calibration inside the REW...

Hi everyone, I’m new to REW. I’m trying to calibrate my soundcard but I don’t seem to find a way to save the Cal File. Every time I try to save the Cal File I get the same message: “Directory not found”, even though the pathway seems to be correct. In fact, no pathway seems to work. I know...

Hi all, I am using the Mackie Onyx Producer 2-2 audio interface, however, when I try to calibrate my sound card with the loopback system, despite having the input level and output level all the way to the maximum, I cannot reach the required -12dbFS "In" level. It is also clipping/distorting at...

Hi, I'm a new user, so please bear over with me. I bought the UMIK-1 mic and have practiced a bit, although I'm a REW-newbie. Now I wish to measure my 5.1 speaker output and characteristics, at their current location in my living room, through my yamaha surround sound receiver. However my...