teyhyrh4r

ok, we're going around in circles here. you simply don't want it. thanks

Well, to begin with, we should acknowledge that this room has an issue that cannot be resolved solely through EQ, right? Anyway, let's...

I'm not quite sure I grasp your meaning. In my opinion, I have demonstrated that this method would result in less degradation across...

There is an impulse alignment mode in the 5.20.14 early access build which avoids that potential issue.

I'm glad that works for you... I have tried both ways with my ML ESLs, a hybrid dipole design, and found in my room with my kit and my...

the ceiling, as you mentioned, is likely acceptable in that situation. However, I personally have concerns about accentuating the...

I'd like to propose an alternative method of averaging, which may be particularly suitable for averaging measurements in multi-seat...

which is a confusing desription isn't it? but 0 degrees is 0 degrees. pointing center you are measuring at an 30 degrees axis

if it is 0 deg, it should be pointed directly to the source. if you point it at center between 2 the mic will capture a little less...

sometimes it is necessary not for the FR, but in order to get the sub close to zero on excess group delay graph. IMO there should be a...

The spectrum plot shows you the level in each frequency bin of the FFT. The more bins (i.e. the longer the FFT), the less energy there...

I which there was a "peak average", meaning that when averaging 2 or more measurements the higher peak would be preserved. I think this...

is it broken, or am I not doing it right? this is a IR of to EQ filters close to 0dB imported with fft 32k: here 64k as soon as...