Recent content by Loupy

I am having a small issue, when I am in the "RTA" page, I cant see the "average the Responses" tab, Which is meant to be at the bottom left corner of the graph Is there a setting for this in "Preference", I am running v5.20.14 Cheers Peter

I am having a small issue, when I am in the "RTA" page, I cant see the "average the Responses" tab, Which is meant to be at the bottom left corner of the graph Is there a setting for this in "Preference", I am running v5.20.14 Cheers Peter

Hi, The mini DP, on my surface laptop, DOES in fact output Audio as well, It was tested with a short lead

Hi Guys, Sounds like the perfect tool to setup my system, If I go, "Digital Version", how do I make the test tones come through my sound system. My DVD player is Sony ubp-x700, it has a USB input on the front and is connected to my Denon X3800 via a HDMI cable

Hi, Thx for your reply, I am actually using the HDMI input (AUX-2) nearest the HDMI output As the X3800 doesn't have a front panel input. Also tried the AUX-1, same thing happens

Hi Everyone, I managed to connect my laptop to my DenonX3800h to do some audio measurements, Everything worked fine, the cable i used was only 1.8 mtrs long from my mini display port on my laptop to the HDMI input on my Denon. With that I went ahead and purchased a 5 mtr mini DP to HDMI...

Hi Guys, I tried installing v5.20.14, and sure enough my mike was recognised, loaded up the cal file, tried to do a level check, then after that.....nothing worked, back to square one where the mik is not recognised

hi guys, my lap top and my desktop doesn't recognised my umik-1 when i plug it in, It comes up with "Device Descriptor Request failed" I have no idea why, it worked fine a few days ago. Any ideas as to why this has happened

Thank, for all your Posts, it has given me a lot to think about. Cheers Peter

Hi DanDan, Thanks for the quick reply, Can you clarify the comment, "but you don't want graphics. ", Cheers

The processor is the UMC-1, Yes I am aware most pre/pro these days do have a variety of eq built in, some are good, some not so much. Ok, Its A Home Cinema room The LCR speakers are passive, MTM's, Surrounds are 2 way bipole's and dipoles, (system is 5.1 at the moment, room has been wired up...

Hardware, want to eq the mains and the sub, but I am guessing the sub will require a separate eq, I havent seen eq that has both. the room is only a smallish size 5mtr x 3.6mtr x 2.4mtr. I realise there are a few things needed to be done, but i figured starting with the mains, getting them...

Hi Guys, I am looking to purchase an Eq. but I dont know which one . Any Advise would be very helpful. Its going to be part of my Home cinema room. Cheers Peter