Recent content by JOSE BEMBIBRE

Hi, Solved¡ I have to deactivate Moom. Best. José

Hi, I´ve tried to install REW on Mac OS 13.3.3. Used both versions 5.19. and 5.20 beta. same result: Install hang when just try select "I accept" on the screen below Attached also, just in case helps, excerpt of Apple Report when finalise the installer. Thanks in advance for the help. Rgds. José...

Hi Thanks¡¡¡¡ Best. José

When you perform a merge the near field measurement normally should be on B to avoid phase adjustments on the far field meas (in A) as part of the merge process. Keeping the IR window of A limit the view of the frequency span merged. i.e the near field until the IR window is expanded. Best. José

Hi, After a merge of near field with a far field measurements, the IR window is the one of the far field, hence if you want to see the SPL full span you must adjust the IR window to the near field width. I am not sure if this behaviour is deliberate or is just a small bug, anyway IMHO is...

Thanks! Issue solved. Br. José

Hi, I´m trying my first SPL measurements with REW (version 5.9 on Mac OSX 10.9.5) I have the following result with a Near Field measurement. As show the frequency range for phase values is more limited than the range for SPL values. Some explanation for this? Thanks in advance. Best regard. José

Just to confirm that you guess was correct. The two inputs of UCA 202 have a very different response: changing the input to Left and reversing the connections accordingly make the measurement almost impossible. Thanks for your help. As a side note will be advisable to indicate some minimal...

Thanks. Make sense, this means that the calibration process does not take in account this asimmetry. Is correct? BTW some recommendations for another card? Thks again Rgds. José

Hi, I´m new on REW so apologies in advance.. The image above is what I get measuring the impedance of a woofer: abnormal high values on low freq. The same happens with a fix resistor.. I use a BEHRINGER UCA 202 with a sharp roll off below 20 Hz nevertheless I have properly calibrated the audio...