John,
I have a question, when we run the measurement for each individual channel (speaker), do we level the volume up or down to SPL signal to 75dB or just a fix volume level to measure each speaker individually?
hi all,
I always have low SPL reading in my REW measurement to speakers, only getting range of 35 to 45dB while i see other are making beyond that, anybody can highlight to me what could be the cause of that. I am using Umik-1 with calibration file input into REW.
Guys,
Today i got a chance to do a quick run of IR practice. I am not sure if i am doing right , the output look a bit weird to me, i attached here the REW file, appreciate if any of you would do a review and help me for correction.
As mentioned, i am now using the left tweeter as my timing...
During my first few attempt, I did bypass the low pass filter on the midbass output channels in DSP. I thought the midbass supposingly able to produce 5kHz?. I will definitely try it to the tweeter accordingly in my next tune session.
Thanks John & Matthew for your input. I am in the learning stage, been reading from other forum about this but i can't make it happen to my system, hence i decided to write here.
Yes, i truly didn't get the timing beep from the reference speaker. May i ask, in doing time delay process, do we...
hi members,
Interesting thread to me here but I've tried it in my car but failed to do so. I wish any experienced members here could further guide me in this matter.
My vehicle is right hand drive. In my case, Left midbass (passenger door) is the furthest speaker so i choose that as timing...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.