Recent content by dcashel

I purchased a SB16 Ultra several month ago, but I have now just found time to get a UMIK1 and load REW on my laptop. My home theater setup if almost exclusively for movies. My setup is 5 NHT super ones, SVS SB16 Ultra, and an old Yamaha RX-V2700. Here are my settings: SB16 Gain = -10 AVR Sub...

I just re-installed the ASIO4ALL and now the ASIO4ALL v2" on the ASIO Device tab shows up. Probably operator error my end.

HI all, I have been using REW on my Windows 10 laptop for a few months now using the Java driver and everything works. I just download ASIO4ALL today to the same Windows 10 laptop. On the Preferences screen I select ASIO on the Drivers tab but when I click on the ASIO Device tab it is blank. I...

I just upgraded to v5.20 and I am using the Generator and SPL Meter in REW with a UMIK-1 to set the output level off all my speakers to 75dB before doing any measurements. Questions: 1.Should I be using Pink Random or Pink Periodic Noise? 2.Should I be using Speaker Cal (500 to 2000Hz) to set...

I am using the Generator and SPL Meter in REW with a UMIK-1 to set the output level off all my speakers to 75dB before doing any measurements. Should I have the REW SPL meter set to C or Z weighting? Many thanks....

Which smoothing in REW is recommended when looking at frequencies below 100Hz and above 100Hz?

Which smoothing in REW is recommended when looking at frequencies below 100Hz and above 100Hz?

Thanks for the help. Before your comment I was going to just leave the Generator and Measurement sweeps levels at there default dBFS values and adjust my AVR volume until the SPL read 75 dB. But, I will follow your instructions instead.

Hi all, I am just started to use REW and have the following question. I am using REW version V5.19. I plan on using the Generator and SPL Meter in REW to set the output level off all my speakers to 75dB before doing any measurements. Does the RMS Level(dBFS) value in the REW Generator and...