I’m using an UMIK-1; it worked,thanks John! It don’t work with asio4all,which worked with the old laptop where was also the REW v5.20 installed; it’s possible it didn’t work on the new one because of the difference between the asio version? I used java and flexasio,and between the two, was a...
Hi guys,have some difficulties with rew setup and measurements; bought a new notebook with windows 10, installed rew ,asio4all, made the settings for the soundcard,all good; was unable to made measurements because in the asio control panel, couldn’t activate the umik1,after that installed java...
Thanks @markscohen! how do I know when is the setting moment before clipping on preamp, miniDsp and power amp,can I measure the input/ output signals on the device? the Marantz preamp has a trim level setting between-12 and +12 dB, on the miniDsp I can set the level a few dB to negative to...
I will also try the “ quick and dirty “ way some time this week. Is it so that with enough input voltage from the pre-pro and the gains at 9 o clock ,the amp can deliver it’s full power?
The speaker trim levels in the processor goes from -12 to +12 db; now, I set the levels in the pre at 0 and the gains on the amp at about 10 o clock, that combination gives the least amount of background noise.
Thanks Dan!
Very helpful article, thanks Wayne! The Marantz has an output sensitivity of 2,4V over xlr and the DCA1622 amps an input sensitivity of 1,2V(+3,9dbu)- don’t know what that means:-) on 8ohm. So I try to lower the gains on the amp and raise the trims in the pre if needed to achieve the lowest...
Hi there! I’ m experimenting with the gain knobs( voltage attenuators) on my qsc dca amps in combination with the marantz av 7702mk2; is there an optimal position for this settings? I’ve read that a power amp can be drive to his full power with the gains turn all the way down( counter clockwise)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.