Recent content by Bergarth

Yes im using 20.14 I have 10 bands selected.

Here is one of them- Im trying to clean up bass a little bit while maintaining its level- but smooth out mid to high

This is what im using to try and get filters to work well with DSP-408- Im sure it probably can be better im not one those smart people- I just know REW refuses to do anything

Drop the level 5DB more maybe that will give REW room to anything at all... again it was like nah you're on your own

So I told my self ok think simple make it Psychoacoustic- maybe there are to many zig zags for the new rew to handle did that and made sure NO HC which is stupid to not be able to use that-- So yea this is what REW is telling me is the best it can do with 10 filters- is to just use one

@John Mulcahy Ok- I hate to be a jerk but this is getting ridiculous- Im trying to tweak my DIY speakers I built using DSP-408 and REW and its still doing same thing refuses to use all the filters even with higher level- I've been at this for two days now and seems REW just gives up right away...

@John Mulcahy Thanks I'll give that a try. I used the target level I did because this is for Home Theater and I tent to use Dynamic EQ- I can always turn that off. That measurement is at -30 on avr, the trim -10 and -5 in miniDSP- these are crazy loud sub setup. The new features are awesome-...

Appreciate it- I know human error can happen but my settings haven't changed that I know of. I love rise to start at 100hz and flatten out at 30hz with average 3- 6db incline. My measurements are always above the correction path so there is no boosting only cuts. Best I can do now still give...

Here are a couple more rew sessions I have done- no issues correcting under 20 hz- no issues getting pretty flat response.. Trying to find my DL of that version so I can go back as I rather not use MSO-

Response is below 20HZ- before updating I could easily correct as low as I needed.. Also its corrections are now lazy- it leaves 3-4 filters unused while giving a crappy response. PRE-20.14 this is how flat I could get my response.. Now it just gives up- if i remove my 120HZ cutoff and drag that...

I cnat get REW to use all ten filters - trying to calibrate my subs with a2X4HD and it only uses 7 and wont even touch 18hz-28ish HZ if i dont unselect allow narrow below 200hz

@John Mulcahy Yes I am, Thanks Ill check that out!

@ddude003 Hmm ill have a look- running 5.20.13 now so maybe .14 is just better

@John Mulcahy The 5.20.13 release- I increased sample to 192- I dont see a "buffer" setting but ill have a look around.,

What is best "save as" for DSP-408? I cant get anything REW suggest for EQ to line up close enough for the DSP-408.