-
-
Hmn, it seems that problem occurs only on testing. When doing measurement, getting signal on speakers correct. -
juicehifi replied to the thread Audiolense XO Version 6.7 - Highpass XOver Results Aren't Viewable On Simulation.Yes, you’re right. I was a bit quick. The simulation shows the combo of speaker and sub. If you want to see the actual crossovers you...
-
juicehifi replied to the thread Audiolense XO Version 6.7 - Highpass XOver Results Aren't Viewable On Simulation.You should do this on the speaker tab, not the xo tab. Currently the bass offloading frequency is set to 250 Hz. So just change it to 70 Hz.
-
juicehifi replied to the thread Acourate versus Audiolense.If you downlad Audiolense and start i (as a demo) you will see that Audiolense supports literally any format. The only limit is max 128...
-
juicehifi replied to the thread Correction overlooks narrow room resonances?.Try to visit the correction procedure designer.
-
Hope you figure it out with the transition regions. AudioLense is already a powerhorse, that can deal with XO and Frequency/Time...
-
juicehifi replied to the thread Correction overlooks narrow room resonances?.You most likely need a larger correction window in the bass.
-
juicehifi replied to the thread New Audiolense releases.Yes, there,s a chanche, but not a certainty. I’ve done some preparations with the data structures, but I haven’t quite figured out how...
-
juicehifi replied to the thread Measurements - How To Determine Which Speaker Caused Clipping?.It will be the one that has the highest spl in some frequency. If your sub causes clipping it’s either the microphone or the ad...
-
Hi everyone, I’ve finally managed to make some real progress, step by step. I am now getting excellent results and can truly appreciate...
-
juicehifi replied to the thread Upgrading license question 2.0 to X0.¡De nada!
-
Loading…
-
Loading…
