Recent content by 408Revo

Hi, first off thanks everyone for all the help everyone has provided me, greatly appreciate it. It’s been a couple months since I fell into this rabbit hole and the more I learn the more amaze I am with using REW. I’m currently working on aligning two subs using a mini DSP. I’ve notice that...

That was the problem, subs were on. Had no idea that a signal was being sent to the subs as well.

I agree. I went at it again today. Tried different variations and no luck. My (2) 12s sound better at my MLP over the (2) 15s. Sending them back and ordering another 12. Hopefully with the third, I’ll get a flatter curve.

Yes, I just reconnected the 12”s instead for now and put my living room back together. A little bummed out that I couldn’t get the 15”s to work for my MLP. I know that my room is not ideal as it opens up to the kitchen and opens up to two other hallways. Going to keep doing research and see what...

I decided to upgrade my dual 12" monolith subs and got dual 15" subs, I got to say that it's a night and day difference. Can't compare the sound dual 15"s give over the 12"s. Unfortunately it did not work for MLP. Almost everywhere else the sound was amazing. Through out the entire house I had...

I feel smart. The whole time when running sweeps the subs were also in the mix. I never thought that when running a sweep on a individual speaker the subs would be included. Greatly appreciate everyone's help on this. Lesson learned, turn off sub when running sweeps on individual speakers. thanks

I went and tried a different speaker. Settings: Audyssey on, speaker set to small, and tried XO at 40 and 250. What am I doing wrong? Blue line is XO at 250 which shows 5 dBs higher at 40htz.

All DSP settings are off

thank you for your response, much appreciated. I agree, the dip in the 200s is a room issue. To further clarify, I'm so new to all this that I don't really know anything on what the different settings really do or even how to use REW. With REW, I'm comfortable to say that I'm able to run a sweep...

To clarify, I'm not using any REW filters. This is just me disabling any DSPs in the receiver and taking sweeps with different receiver crossover settings and with speakers set to small or large. I'm trying to understand what these receiver settings are actually doing to the speakers by using...

why am I getting similar results when I run my speaker set to small?

All DSP settings are off and speaker set to large. It's probably just me not able to read the graph correctly or I have a setting on REW that is not allowing to measure? Why would I have higher dBs at 30htz with a 250 XO than 40?

Hi, I'm a newbie with REW and trying to understand how the different crossover settings affect a single speaker. Using a Denon with Audyssey turned off and my speaker set to large, I ran two sweeps, one with the crossover set to 250 and another set to 40. I noticed that with a XO at 250, there...

Thank you Wayne, appreciate your response. For some reason I thought it was a complete cut off. From the little I know when a speaker is set to small, all LFE gets routed to the sub regardless of the xover setting? When set to large, only the frequencies below xover get routed to the sub...

Hi everyone, I'm new to this so please bear with me if the answer is obvious. I know this topic has been discussed all over the net but I can't find the information I'm looking for. I'm trying to understand exactly what these setting do to a speaker. I did some tests on REW to try to understand...