ddude003
Senior AV Addict From Somewhere Northeast of Kansas City Missouri
- Joined
Latest Activity Postings Showcase items About
-
-
-
ddude003 replied to the thread What are you listening to right now?.
-
-
ddude003 replied to the thread What are you listening to right now?.
-
-
ddude003 reacted to Wayne A. Pflughaupt's post in the thread How to eq sub only and intergrate with mains with
Like.
The best way to keep subs from interfering with the main speakers is to high pass the latter, thereby allowing the subwoofer to handle... -
ddude003 reacted to Wayne A. Pflughaupt's post in the thread How to eq sub only and intergrate with mains with Like.
Yes, I understood the problem from what you described in your first post. Give us a full-range measurement of each of your main...
-
ddude003 replied to the thread How to eq sub only and intergrate with mains.The specs for the Harbeth P3ESR are: A Two-way, sealed-cabinet, stand-mounted loudspeaker. Drive-units: 0.75" (19mm) magnetically...
-
ddude003 reacted to Lid9497's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with
Love.
Hey, back with an update. I've finally found a good listening position where MSO has the most to work with. I measured two completely... -
ddude003 reacted to John Mulcahy's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
Not particularly, but it is best to capture the bandwidth of the driver being measured and for this sub there is still significant...
-
ddude003 reacted to sm52's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
John Mulcahy, The blue graph has a shaky look. See post #33. What is the cause for this phenomenon?
-
ddude003 reacted to John Mulcahy's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
Everything above 500 Hz or so is noise as the sub has no output there.
-
ddude003 reacted to JStewart's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
Home from vaca and looked at the .mdat. I'm not knowledgeable enough to explain the differences in the delay calculations. I would...
-
ddude003 reacted to JStewart's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
It shouldn’t matter, but there’s no point in capturing a lot of noise. A few hundred Hz should be fine. To verify all is working...
-
ddude003 reacted to JStewart's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
I think @Lid9497 has used MSO to already set the subwoofers as a group and at this point needs to set subs group to the mains. If I’m...
-
ddude003 reacted to sm52's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
To answer, you have to take 4 measurements. Left main, right main, near sub, far sub. All 4 with acoustic synchronization by, for...
-
ddude003 reacted to sm52's post in the thread Crossover, speaker alignment, room equalization - what do I start with? with Like.
I'm not looking at the numbers you're looking at. I look at the source, at the graphs. Between the first peaks there are 386...
-
-
Loading…
-
Loading…
-
Loading…
