output

  1. M

    Sound Card Calibration unable to reach required level

    Hi all, I am using the Mackie Onyx Producer 2-2 audio interface, however, when I try to calibrate my sound card with the loopback system, despite having the input level and output level all the way to the maximum, I cannot reach the required -12dbFS "In" level. It is also clipping/distorting at...
  2. K

    Windows 10 not outputting to all channels

    Hello all, I've looked through the available information here but have not found anything resembling my issue, so here it is. My AVR is connected to computer via HDMI and it sees 7.1 and I can hear test tones from each speaker when using windows sound settings. In Rew it will not play individual...
  3. Dante Cry

    Problem Calibration

    Hello everyone, I allow myself to write here because I find myself facing a problem that I can not understand or solve. I wish to make the acoustic measurements of my home studio, only I can not properly calibrate my sound card with REW. Here is my problem: My input gain level is much too...
  4. L

    REW Beta Release on linux problems with output

    Hi everybody, at the moment i m trying put up a setup for measurment i use - linux debian (#bunsenlabs distribution) - native instruments audio8 soundcard in the preferences i use "pulseaudio mixer" as output and input. in the mixer i should be able to route the signal to the sound card...
Top Bottom