whoareyou

Cfg: It means that you need to check that the correction procedure works for the highest sample rate. I doubt that there is anything...

For me, I think this explains what I hear with resampled SACD playback at higher bitrate playback and AL filter (352.8 converted SACD...

I don't have a receiver. Only the 2.1 setup with AL and HLC. For videos I use the minimal delay filters with only one loaded on HLC...

On critical listening (and instant switching with something like HangLoose Convolver), I prefer the mixed phase, since it seems to pull...

Of course it's partly personal taste, but it's also based on a good deal of scientific research.

Hey Ofer, On the target just change selection to Mix Phase Targets and then enter amounts bottom right of input form

So, your issues are mostly with measurements?

Is driver overlap supposed to work only with front left and front right full range? I ask because I was playing around with similar...

Also, the response from crossspectrum: "What you’re seeing is normal. The issue is that the UMIK-1 has a fixed sampling rate of 48 kHz...

This may be of interest to some...

I just thought I'd share another little trick to increase gain a bit more (only a relevant issue if you have a low gain system, or less...

I disagree. For most microphones, the variations in their frequency response is much bigger than what an objective measurement can...

Thanks for the suggestion. And yes, I understand that the microphone may be able to measure much higher, but I suspect this one does...

I strongly recommend individually calibrated microphones. Significant frequency deviations that are audible occur regularly and it is...

The attachment has the "correct" file. It is the reason for my post as it seems very much out of whack in those upper frequencies. I am...