-
-
VVladimir_1953 replied to the thread How to set the cursor on the charts to the zero mark?.In which window in REW do I set this level when setting up and measuring?
-
VVladimir_1953 replied to the thread How to set the cursor on the charts to the zero mark?.The factory datasheet for Thiele/Small specifies exactly this voltage 2.83 volts. *** SensitivityThe sound pressure, in dB, produced...
-
VVladimir_1953 replied to the thread How to set the cursor on the charts to the zero mark?.I always try to take measurements at a voltage of 2.83V on a 4 ohm load equivalent, which is indicated in the passport specifications.
-
-
VVladimir_1953 replied to the thread How to set the cursor on the charts to the zero mark?.I would agree with you if we were talking about measuring the SPL. I have provided an Impedance graph. The measurement mode is 2-channel.
-
VVladimir_1953 replied to the thread How to set the cursor on the charts to the zero mark?.I use REW 5.31.3
-
VVladimir_1953 replied to the thread How to set the cursor on the charts to the zero mark?.Thank you, John! I activated the options as you recommended. But I can't set =0, only a little higher or a little lower. Is it possible...
-
-
VVladimir_1953 replied to the thread How to set the cursor on the charts to the zero mark?.What is the exact frequency of the port tuning? I always thought that the zero crossing was the absolute indicator. How and with what...
-
VVladimir_1953 posted the thread How to set the cursor on the charts to the zero mark? in Official REW (Room EQ Wizard) Support Forum.Hello everyone! How to tie the cursor position on the phase grid to the zero mark? It is not set quite accurately yet. This is necessary...
-
-
-
Loading…
-
Loading…
