Therefore I will first need to build that circuit, and using the integrated soundcard (won't be ideal but it's stereo) both for the output and the input I will have to do the "open circuit calibration" on REW with the speaker disconnected (or the switch in the CAL position) while entering the...
hello. thank your for your response. i have a way simpler and less accurate setup than yours, which consists in a AV Harman/kardon amplifier and a PC. I have a behringer umc-22 soundcard, which has stereo output and mono input, therefore I have to use the line-in on my integrated soundboard...
Hello everyone. I've been using REW for quite some time and it's a very powerful software. I made my impedance measurement rig as described on the REW website and I used the headphone output and line input from my soundcard.
However, I'd like to use an amplifier to drive the speakers for more...
Thank you for the response! I had two pairs of speakers of the same model so I thought that the best way to obtain TSPs was to average the impedance graph and then do the calculation, I guess I have to do the average once I obtained the parameters.
Hello! I've been using this wonderful piece of software for about 5 months, since 5.2.0 RC5. So far everything has been pretty good, I've encountered some minor glitches but nothing serious.
However, now I'm having problems with REW. Basically I've made an impedance measurement of a tweeter I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.