Veleric

John, Thanks for your patience with me, I made some errors in my previous post. Typing with too much distraction and not enough...

John, Ahh yes, that's correct. I didn't even think to mention that, as I've been using it so long that I forogt about that. When I was...

I got the Startech Interface and the Umik-1 mic and have successfully loaded the cal file, set up the inputs and outputs, and made...

thanks John!

So there’s no reason to include the Sherwood in the set up for the impedance measurement? Is that correct?

Okay, I'm leaning toward the Startech. Assuming I get the Startech 7.1 USB Sound Card, and UMIK-1, would the following be the right...

What about this? Any better? If not, then this Steinberg UR12? If I get a UMIK-1 and use it in combination with either of these...

John, Could it be something as basic as this? Would I also be able to do impedance measurements using this...

Thanks John, I'll look one more time for those specific settings. Is there any chance the issue is in the HDMI to RCA converter that I'm...

John, Thanks. So I was finally able to run the soundcard calibration using the EXCL drivers. By "preadjusting" the level, I was able to...

John, Okay, hitting the space bar works to advance through the steps, until I have the input level set. Then when I press the space bar...

John, Here is what it looks like: I tried changing the Input and Loopback inputs (L/R) to both R, but the result was the same. No...

John, I downloaded the 5.20.13 release. I can make measurements using either the default drivers or the EXCL drivers, but, when I try...

Thanks John, I'll check those out. Eric

@John Mulcahy Hey John, would appreciate any comments you might have about the soundcard calibration in the previous post. Is it okay...